Regency 4734 Manual de Instalação descarregar pdf (Página 27)

Regency

Model 4734 Access Control Expander Installation Manual (P/N 150807, Rev. A) Revised 5/98

BELL TST PU:NO (bell test at power-up)

This option causes the system to sound a two-second bell test whenever the system is reset.

DIALER:YES

The dialer must always be selected for normal operation. It can be disabled for troubleshooting

or while training end users. When the dialer is disabled, there is no battery or AC detection.

PRINTER:NO

Select this option if you are using a Model 5260 Printer Interface.

ZONE EXP1:NO

If at least one zone expander is to be used with the system, this option must be selected.

ZONE EXP2:NO

If two zone expanders are to be used with the system, both ZONE EXP1 and ZONE EXP2

must be selected.

INTERCOM:NO

Select this option if you are using the Model 4140 Intercom Module.

AUX CONTROL:NO

Select this option if you are using the Model 4150 Auxiliary Control Module.

INTERN ZONES:16

Select the number of internal zones used (zones built into the 4720 panel). This will let the sys-

tem know where to start the expansion zones.

EXP ZONES#1:0

Enter the number of zones on Expander #1.

RESD CODE#1:0123

Select the residence code to be used with RF Zone Expander #1. This code must be the same as

the residence code programmed into the transmitters; see the section on expansion zones in the

4720 Installation Manual (P/N 150476). Skip this step if NOT using an RF zone expander.

Table 6: Default Mode Selections

Selection Default Mode

The system will default to the DISARMED mode and will NOT generate an

Open Report to the central station.

The system will default to the DISARMED mode and WILL generate an Open

Report.

The system will default to the ARMED mode and will automatically bypass

(shunt) any zones that are not ready to be armed. The system will also gener-

ate a Close Report.

The system will default to the ARMED Mode. If any zones are not ready to be

armed, they will go into the ALARM condition and the appropriate report will be

sent to the central station. If all of the zones are ready, only a Close Report will

be generated.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 69 70

Sem comentários

Regency 4734 Manual de Instalação Página 27