Regency FireGenie Instruções de Operação descarregar pdf (Página 17)

FPI FireGenie

Remote Control Manual Page 17

Time Zone 1

On-Time Off-Time

8:00 am 2:00 pm

1:00 pm 4:00 pm

On-Time Off-Time

Time Zone 2

Operates under Time Zone 1

Setting

Operates under Time Zone 2 Setting

Matching Remote Handset and Control Box ID Code

The Remote Control Handset has a set of unique ID codes that is pre-programmed into its

memory. This set of ID codes helps to differentiate one Remote Control Handset from

another so that only the control box with a matching ID code will respond to the

appropriate Remote Control Handset.

To match the control box, the following steps are to be followed:

1. Ensure the Remote is switched OFF.

2. Remove main power to the control box.

3. Reconnect main power to the control box.

4. Press and hold the PROG and FAN buttons simultaneously. The temperature

display will show the letters “LC” momentarily indicating the ID codes have been

transmitted.

5. The display will revert back to the normal off mode display.

6. Release both the PROG and FAN buttons.

The control box will only learn the Remote ID codes during the first 30 seconds after

power is applied and will ignore this special command from the Remote after the first 30

seconds.

NOTE: This must only be performed by a qualified installer.

1 2 ... 12 13 14 15 16 17 18 19 20

Sem comentários

Regency FireGenie Instruções de Operação Página 17